Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Pictures) |
(→Turning front drive into rear drive) |
||
Zeile 28: | Zeile 28: | ||
File: Ardumower_mountains5.jpg| Step 3: Add rubber band | File: Ardumower_mountains5.jpg| Step 3: Add rubber band | ||
File: Ardumower_mountains2.jpg| Step 4: Modify charging station | File: Ardumower_mountains2.jpg| Step 4: Modify charging station | ||
− | File: Ardumower_mountain_tires.jpg| Step | + | File: Ardumower_mountain_tires.jpg| Step 5a: Modify tire profile |
+ | File: Ardumower_tire_mod_off_road2.jpg | Step 5b: 'Off-road' tire mod using bicycle tube | ||
</gallery> | </gallery> | ||
Version vom 20. Juni 2015, 20:10 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to run up higher slopes with it (tested up to 14 degree). This works by
- turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front)
- modifying the tire profile (give it more grip)
- Modify tire profile OR
- Off-road version (sand etc.): A bicycle tube is added around the tire
Needed parts
- cup
- acrylic glas sheet
- rubber band
Turning front drive into rear drive
- swap motor cables (right and left)
- swap odometry cables (right and left)
- swap battery charging pin cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side