Bumper sensor: Unterschied zwischen den Versionen

Aus www.wiki.ardumower.de
Wechseln zu: Navigation, Suche
(Code)
(Abstract)
Zeile 7: Zeile 7:
 
File: Ardumower_BumperDuino.jpg | BumperDuino PCB
 
File: Ardumower_BumperDuino.jpg | BumperDuino PCB
 
File: Ardumower_bumperduino_outdoor.jpg | BumperDuino pressure sensor tube
 
File: Ardumower_bumperduino_outdoor.jpg | BumperDuino pressure sensor tube
 +
File: Bumperduino_example.jpg | BumperDuino example
 
File: Bumperduino_pressure_sensor.jpg | BumperDuino pressure sensor tube
 
File: Bumperduino_pressure_sensor.jpg | BumperDuino pressure sensor tube
 
File: Bumperduino_workshop.jpg | BumperDuino building instructions
 
File: Bumperduino_workshop.jpg | BumperDuino building instructions

Version vom 10. April 2016, 10:27 Uhr

Abstract

Ardumower's bumper sensor (called 'BumperDuino') is based on a pressure sensor and helps us to detect obstacles.

The PCB module and sensor can be purchased as complete kit via the shop Shopping.png .

Building instructions

Building instructions as well as instructions for programming the Arduino can be found in the BumperDuino manual.

Schematics

  1. GitHub folder
  2. Schematics

Code

You can download the Arduino Code here. Important: Choose 'Arduino Uno' as bootloader.

To upload the code, set jumper to 'VUSB' and connect an USB-TTL adapter to J4 (USB-LIGHT) as follows:

J4 (USB-LIGHT)
1 -- USB-TTL GND
2 -- not used
3 -- USB-TTL +5V
4 -- USB-TTL TX
5 -- USB-TTL RX
6 -- USB-TTL DTR (reset)

All steps are described in more detail here: FT232RL USB-adapter manual.

Connecting to Ardumower

Set jumper to 'VIN', and connect VIN and BUMPER-OC to Ardumower as follows:
VIN
(+) -- 9-12V
(-) -- GND

BUMPER-OC
DC1 -- Ardumower bumper left/1
DC2 -- Ardumower bumper right/2

Videos

  1. Introduction BumperDuino
  2. Making Of BumperDuino