PCB 1.3 (English): Unterschied zwischen den Versionen

Aus www.wiki.ardumower.de
Wechseln zu: Navigation, Suche
(Videos)
Zeile 5: Zeile 5:
  
 
<b>NOTE: WE ARE CURRENTLY WORKING ON THIS PAGE - PLEASE LOOK AT PCB 1.2 FOR MISSING INFORMATION</b>
 
<b>NOTE: WE ARE CURRENTLY WORKING ON THIS PAGE - PLEASE LOOK AT PCB 1.2 FOR MISSING INFORMATION</b>
 +
 +
=Checklist=
 +
* set Jumper JP13 on PCB back side for a Marotronics Arduino Due (for automatic reset)
 +
* set Jumper JP12 (GPS signal voltage) to 3.3VP for Marotronics GPS module
 +
* set Jumper JP7 (GPS operating voltage) to 5VP for Marotronics GPS module
 +
* set Jumper JP10 (Bluetooth signal voltage) to 3.3VP for Marotronics Bluetooth module
 +
* set Jumper JP4 (Bluetooth operating voltage) to 5V for Marotronics Bluetooth module
 +
* set Jumper JP6 (WIFI operating voltage) to 3.3V for Marotronics WIFI module
 +
* set Jumper JP11 (WIFI signal voltage) to auf 3.3V for Marotronics WIFI module
 +
* set Jumper JC2 (IMU signal voltage) to 3.3V for Marotronics IMU module
 +
* only set Jumpers JC2, JC3, JC4, JC5, JC6, JC7 if there is a corresponding I2C module installed
 +
* press button P20 to power-on PCB
 +
  
 
=Schematics, Drawings, Photos=
 
=Schematics, Drawings, Photos=

Version vom 9. Juli 2017, 17:50 Uhr

Steps

Pcb1 3.jpg

This page describes how to assemble PCB 1.3, how to add modules and how to configure the PCB.

NOTE: WE ARE CURRENTLY WORKING ON THIS PAGE - PLEASE LOOK AT PCB 1.2 FOR MISSING INFORMATION

Checklist

  • set Jumper JP13 on PCB back side for a Marotronics Arduino Due (for automatic reset)
  • set Jumper JP12 (GPS signal voltage) to 3.3VP for Marotronics GPS module
  • set Jumper JP7 (GPS operating voltage) to 5VP for Marotronics GPS module
  • set Jumper JP10 (Bluetooth signal voltage) to 3.3VP for Marotronics Bluetooth module
  • set Jumper JP4 (Bluetooth operating voltage) to 5V for Marotronics Bluetooth module
  • set Jumper JP6 (WIFI operating voltage) to 3.3V for Marotronics WIFI module
  • set Jumper JP11 (WIFI signal voltage) to auf 3.3V for Marotronics WIFI module
  • set Jumper JC2 (IMU signal voltage) to 3.3V for Marotronics IMU module
  • only set Jumpers JC2, JC3, JC4, JC5, JC6, JC7 if there is a corresponding I2C module installed
  • press button P20 to power-on PCB


Schematics, Drawings, Photos

Videos

Forum

http://www.ardumower.de/index.php/de/forum/ardumower-pcb/1348-building-instruction-for-the-1-3-board