PCB 1.3 (English): Unterschied zwischen den Versionen

Aus www.wiki.ardumower.de
Wechseln zu: Navigation, Suche
(Checklist)
(Checklist)
Zeile 33: Zeile 33:
 
* only set jumpers JC2, JC3, JC4, JC5, JC6, JC7 if there is a corresponding I2C module installed
 
* only set jumpers JC2, JC3, JC4, JC5, JC6, JC7 if there is a corresponding I2C module installed
 
* set jumper JP8 to 'Always-ON' for tests and for Arduino uploads, for regular operation (and automatic undervoltage power-off) to 'Automatic'
 
* set jumper JP8 to 'Always-ON' for tests and for Arduino uploads, for regular operation (and automatic undervoltage power-off) to 'Automatic'
 +
* RTC module must be installed for proper I2C bus operation
 
* press button P20 to power-on PCB
 
* press button P20 to power-on PCB
  
 
=Forum=
 
=Forum=
 
http://www.ardumower.de/index.php/de/forum/ardumower-pcb/1348-building-instruction-for-the-1-3-board
 
http://www.ardumower.de/index.php/de/forum/ardumower-pcb/1348-building-instruction-for-the-1-3-board

Version vom 9. Juli 2017, 18:17 Uhr

Steps

Pcb1 3.jpg

This page describes how to assemble PCB 1.3, how to add modules and how to configure the PCB.

NOTE: WE ARE CURRENTLY WORKING ON THIS PAGE - PLEASE LOOK AT PCB 1.2 FOR MISSING INFORMATION

Schematics, Drawings, Photos

Videos

Checklist

  • set jumper JP13 on PCB back side for a Marotronics Arduino Due (for automatic reset)
  • set jumper JP12 (GPS signal voltage) to 3.3VP for Marotronics GPS module
  • set jumper JP7 (GPS operating voltage) to 5VP for Marotronics GPS module
  • set jumper JP10 (Bluetooth signal voltage) to 3.3VP for Marotronics Bluetooth module
  • set jumper JP4 (Bluetooth operating voltage) to 5V for Marotronics Bluetooth module
  • set jumper JP6 (WIFI operating voltage) to 3.3V for Marotronics WIFI module
  • set jumper JP11 (WIFI signal voltage) to auf 3.3V for Marotronics WIFI module
  • set jumper JC2 (IMU signal voltage) to 3.3V for Marotronics IMU module
  • only set jumpers JC2, JC3, JC4, JC5, JC6, JC7 if there is a corresponding I2C module installed
  • set jumper JP8 to 'Always-ON' for tests and for Arduino uploads, for regular operation (and automatic undervoltage power-off) to 'Automatic'
  • RTC module must be installed for proper I2C bus operation
  • press button P20 to power-on PCB

Forum

http://www.ardumower.de/index.php/de/forum/ardumower-pcb/1348-building-instruction-for-the-1-3-board