AzuritBer Pi Firmware (English): Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Level 2 Raspberry Pi) |
(→Level 2 Raspberry Pi) |
||
| Zeile 9: | Zeile 9: | ||
[[Datei:pi3_board.jpg|100px]] | [[Datei:pi3_board.jpg|100px]] | ||
| − | 1 DC/DC voltage regulator to power the PI. | + | 1 DC/DC voltage regulator to power the PI.Minumum 5A version from marotronics |
| − | [[Datei:DC DC 5A.jpg|100px]] | + | [[Datei:DC DC 5A.jpg|100px]] https://www.marotronics.de/5A-DC-DC-step-down-module-XL4015-with-heat-sink-eg-for-Arduino |
| − | + | ||
| − | https://www.marotronics.de/5A-DC-DC-step-down-module-XL4015-with-heat-sink-eg-for-Arduino | + | |
1 USB mouse,keyboard for setting.You can simply use a standard one for the setting and disconnect it after But it's also possible to use a small one like that to drive the mower remotly in manual mode. | 1 USB mouse,keyboard for setting.You can simply use a standard one for the setting and disconnect it after But it's also possible to use a small one like that to drive the mower remotly in manual mode. | ||
Version vom 4. November 2020, 19:11 Uhr
Level 2 Raspberry Pi
A Raspberry Pi is connected over Due Native USB to the arduino
You need
1 Raspberry PI 3B+ or PI4 (The Pizero W can work but very slowly and it's not the goal).
1 DC/DC voltage regulator to power the PI.Minumum 5A version from marotronics
https://www.marotronics.de/5A-DC-DC-step-down-module-XL4015-with-heat-sink-eg-for-Arduino
1 USB mouse,keyboard for setting.You can simply use a standard one for the setting and disconnect it after But it's also possible to use a small one like that to drive the mower remotly in manual mode.
1 SD Card 32 GB class 10
