Alfred Assembly

This page describes the assembly of the Alfrd DIY kit that you can purchase via the [1] .

Videos

1. Alfred DIY - Montage des Bedienpanels
2. Montage der RTK Basisstation | Assembly of RTK base | ArduMower / Alfred

Assembly of the LED-Board

• 

  Alfred_LED_Board 1

• 

  Alfred_LED_Board 2

• 

  Alfred_LED_Board 3

Connection of electricity thieves

• 

  Alfred_ElectricityThieves 1

• 

  Alfred_ElectricityThieves 2

The enclosed electricity thieves are to divert the supply voltage from Alfred. Please press the black cable (-) to the black cable from the red connector (battery cable) and the red cable (+) to the black cable from the blue connector (on/off switch).

Remaining ribbon cable from the control panel

You can remove or cut off the two remaining ribbon cables on the original control panel, insulate the ends and stow them in the housing.