DIY Brushless Driver Board
DIY ArduMower Brushless Driver Board
In this chapter you will find the information about the DIY ArduMower Brushless Driver, based von TI DRV8308 Chip.
Description
DIY ArduMower Brushless Driver, this is a not configured Driver, as it comes out of the factory. It is for experts, able to program there own configuration to the device. It is needed if you want to use another mower than an ArduMower with other types fo motors. For this, you need expert knowledge about electronics / brushless motors and software skill. With this kits, you are working on you own risk.
One IMORTANT notice at the beginning: The OTP ROM, where you have to store the program parameter for your motor, can programmed only ONE time! OTP-ROM changes afterwards are not possible. So please think twice before you burn the parameter into OTP-ROM. More on this later in this article.