Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Abstract) |
(→Abstract) |
||
Zeile 1: | Zeile 1: | ||
=Abstract= | =Abstract= | ||
− | This page describes how to modify the Ardumower Chassis to run up higher slopes with it (up to 45 percent). This works by | + | This page describes how to modify the Ardumower Chassis to run up higher slopes with it (tested up to 45 percent). This works by |
#turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front) | #turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front) | ||
#modifying the tire profile (give it more grip) | #modifying the tire profile (give it more grip) |
Version vom 6. Februar 2015, 00:24 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to run up higher slopes with it (tested up to 45 percent). This works by
- turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front)
- modifying the tire profile (give it more grip)
Needed parts
- cup
- acrylic glas sheet
- rubber band
Turning front drive into rear drive
- swap motor cables (right and left)
- swap odometry cables (right and left)
- swap battery charging pin cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side