Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Abstract) |
(→Abstract) |
||
Zeile 1: | Zeile 1: | ||
=Abstract= | =Abstract= | ||
− | This page describes how to modify the Ardumower Chassis to make it ready for higher slopes (up to 45 degree). This works by changing the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front) | + | This page describes how to modify the Ardumower Chassis to make it ready for higher slopes (up to 45 degree). This works by changing the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front): |
* swap motor cables (right and left) | * swap motor cables (right and left) | ||
* swap odometry cables (right and left) | * swap odometry cables (right and left) |
Version vom 17. September 2014, 05:32 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to make it ready for higher slopes (up to 45 degree). This works by changing the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front):
- swap motor cables (right and left)
- swap odometry cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side
Needed parts
- cup
- acrylic glas sheet
- rubber band