Ardumower Sunray: Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Compass calibration) |
|||
Zeile 9: | Zeile 9: | ||
=Compass calibration= | =Compass calibration= | ||
# Install IMU module 35cm away from metal parts. Use 1m cable so you can move the module out of robot for calibration. | # Install IMU module 35cm away from metal parts. Use 1m cable so you can move the module out of robot for calibration. | ||
− | [[File:Verteileraufputzdose_2017-01-22.jpg]]. Do no use metal parts (screws etc.) within 5cm of the module, use plastic screws. Fixate everything within 5cm of the module. A small movement of a cable etc. will make the calibration useless. | + | [[File:Verteileraufputzdose_2017-01-22.jpg]]. |
+ | Do no use metal parts (screws etc.) within 5cm of the module, use plastic screws. Fixate everything within 5cm of the module. A small movement of a cable etc. will make the calibration useless. | ||
# Move IMU out of robot and power-on robot. | # Move IMU out of robot and power-on robot. | ||
# On the PC, start 'processing_mag'. | # On the PC, start 'processing_mag'. |
Version vom 29. April 2017, 15:43 Uhr
Requirements
- PCB 1.3 (incl. MC33926 motor drivers)
- Arduino Due
- IMU GY-88 (MPU6050, HMC5883L)
- 2 perimeter coils (left, right), perimeter sender
- motors using odometry
- Bluetooth module
Compass calibration
- Install IMU module 35cm away from metal parts. Use 1m cable so you can move the module out of robot for calibration.
.
Do no use metal parts (screws etc.) within 5cm of the module, use plastic screws. Fixate everything within 5cm of the module. A small movement of a cable etc. will make the calibration useless.
- Move IMU out of robot and power-on robot.
- On the PC, start 'processing_mag'.
- Ensure there is at least >1m to all metal parts in the surrouding.
- Rotate IMU module slowly into all directions and collect > 20,000 measurements.
- Install IMU module in the robot at least 35cm away from metal parts.