Alfred Assembly: Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
BenPan (Diskussion | Beiträge) (→Remaining ribbon cable from the control panel) |
(→Remaining ribbon cable from the control panel) |
||
| Zeile 32: | Zeile 32: | ||
You can remove or cut off the two remaining ribbon cables on the original control panel, insulate the ends and stow them in the housing. | You can remove or cut off the two remaining ribbon cables on the original control panel, insulate the ends and stow them in the housing. | ||
| + | |||
| + | |||
| + | ==Programming your Alfred MCU firmware== | ||
Version vom 17. Mai 2023, 10:08 Uhr
This page describes the assembly of the Alfrd DIY kit that you can purchase via the [1] 
.
Inhaltsverzeichnis
Videos
- Alfred DIY - Montage des Bedienpanels
- Montage der RTK Basisstation | Assembly of RTK base | ArduMower / Alfred
Assembly of the LED-Board
Alfred_LED_Board 1
Alfred_LED_Board 2
Alfred_LED_Board 3
Connection of electricity thieves
Alfred_ElectricityThieves 1
Alfred_ElectricityThieves 2
The enclosed electricity thieves are to divert the supply voltage from Alfred. Please press the black cable (-) to the black cable from the red connector (battery cable) and the red cable (+) to the black cable from the blue connector (on/off switch).
Remaining ribbon cable from the control panel
You can remove or cut off the two remaining ribbon cables on the original control panel, insulate the ends and stow them in the housing.
