Chassis 2021: Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Clamping element will not tighten shaft anymore) |
(→Clamping element will not tighten shaft anymore) |
||
Zeile 99: | Zeile 99: | ||
* press together the outer clamping element in a bench vise | * press together the outer clamping element in a bench vise | ||
− | * OR | + | * OR use a filling under the 'ring'. Soda/beer can strip works fine for that. Wedged parts has slits, make sure those are not towards each other nor towards shaft d-slot. |
− | * OR | + | * OR add a heat shrink tubing over the inner clamping element as shown in the photo ('''NOTE: this is a temporary solution and may not last forever as the heat shrink tubing may dissolve over time'''): |
<gallery> | <gallery> |
Version vom 27. August 2021, 10:40 Uhr
This page describes the assembly of the Ardumower chassis that you can purchase via the shop .
Related pages:
Please start watching the detailed instruction videos on Youtube (see section "Videos"). This page is based on the content of the videos.
Inhaltsverzeichnis
Videos
- Ardumower Tutorials Chassis 2021 Teil 1 WasGehoertDazu
- Ardumower Tutorials Chassis 2021 Teil 2 Vorbereitung
- Ardumower Tutorials Chassis 2021 Teil 3 Montage
Tools
- Screw driver
- Different Imbus screw driver
- Different Torx screw driver
- Knife
- Round and flat file
- sand paper or sand sponge
- Drill machine with drill set (3,4,6,8,10 mm drills)
Whats inside the Box?
Preparation of Plate-Materials
Front-Plate
Mount the three Sonar-Sensors with hot-glue (carefully).
Mow-Plate
Inserting the threaded sleeves for the mower blades.
Wiring
There are two options to wire the emergency switch. Option 2 is the recommended version. If you realize version 1, don´t forget an external accessible power-Switch (close to "connector") .
Case assembly
Maintenance & Repair Tips
Clamping element will not tighten shaft anymore
If your 'clamping' element will not tighten shaft anymore (e.g. due to a slightly reduced shaft diameter), you may:
- press together the outer clamping element in a bench vise
- OR use a filling under the 'ring'. Soda/beer can strip works fine for that. Wedged parts has slits, make sure those are not towards each other nor towards shaft d-slot.
- OR add a heat shrink tubing over the inner clamping element as shown in the photo (NOTE: this is a temporary solution and may not last forever as the heat shrink tubing may dissolve over time):