Chassis 2021: Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Clamping element will not tighten anymore) |
(→Clamping element will not tighten shaft anymore) |
||
Zeile 96: | Zeile 96: | ||
==Clamping element will not tighten shaft anymore== | ==Clamping element will not tighten shaft anymore== | ||
− | If your 'clamping' element will not tighten anymore (e.g. due to a smaller shaft diameter), add a heat shrink tubing as shown in the photo: | + | If your 'clamping' element will not tighten shaft anymore (e.g. due to a smaller shaft diameter), add a heat shrink tubing as shown in the photo: |
<gallery> | <gallery> | ||
File: clamping_element_tube1.jpg | File: clamping_element_tube1.jpg |
Version vom 25. August 2021, 16:44 Uhr
This page describes the assembly of the Ardumower chassis that you can purchase via the shop .
Related pages:
Please start watching the detailed instruction videos on Youtube (see section "Videos"). This page is based on the content of the videos.
Inhaltsverzeichnis
Videos
- Ardumower Tutorials Chassis 2021 Teil 1 WasGehoertDazu
- Ardumower Tutorials Chassis 2021 Teil 2 Vorbereitung
- Ardumower Tutorials Chassis 2021 Teil 3 Montage
Tools
- Screw driver
- Different Imbus screw driver
- Different Torx screw driver
- Knife
- Round and flat file
- sand paper or sand sponge
- Drill machine with drill set (3,4,6,8,10 mm drills)
Whats inside the Box?
Preparation of Plate-Materials
Front-Plate
Mount the three Sonar-Sensors with hot-glue (carefully).
Mow-Plate
Inserting the threaded sleeves for the mower blades.
Wiring
There are two options to wire the emergency switch. Option 2 is the recommended version. If you realize version 1, don´t forget an external accessible power-Switch (close to "connector") .
Case assembly
Maintenance & Repair Tips
Clamping element will not tighten shaft anymore
If your 'clamping' element will not tighten shaft anymore (e.g. due to a smaller shaft diameter), add a heat shrink tubing as shown in the photo: