Soldering The Sender: Unterschied zwischen den Versionen
Roland (Diskussion | Beiträge) |
Roland (Diskussion | Beiträge) |
||
Zeile 35: | Zeile 35: | ||
[[File:SenderSoldering23.JPG|none|thumb|Put in the pins for the MC33926 motor driver|800px]] | [[File:SenderSoldering23.JPG|none|thumb|Put in the pins for the MC33926 motor driver|800px]] | ||
[[File:SenderSoldering24.JPG|none|thumb|Install the motor driver and solder it. For a) Solder also the two right pins (original Ardumower config) For b)remove the the two right pins later|800px]] | [[File:SenderSoldering24.JPG|none|thumb|Install the motor driver and solder it. For a) Solder also the two right pins (original Ardumower config) For b)remove the the two right pins later|800px]] | ||
− | [[File:SenderSoldering25.JPG|none|thumb|Solder the terminal blocks. For a) You have two pins soldered between the terminal blocks | + | [[File:SenderSoldering25.JPG|none|thumb|Solder the terminal blocks. For a) You have two pins soldered between the terminal blocks For b) you have to solder in 3 terminal blocks|800px]] |
− | [[File:Ardumower sender pcb.jpg|none|thumb|Board with all components - default Ardumower configuration|800px]] | + | [[File:Ardumower sender pcb.jpg|none|thumb|a) Board with all components - default Ardumower configuration|800px]] |
− | [[File:SenderSoldering26.JPG|none|thumb|Board using external power supply for Vin and GND for the perimetersignal. Three terminal blocks installed on the motor driver because Vin and GND of the motordiver are not connected to the sender board|800px]] | + | [[File:SenderSoldering26.JPG|none|thumb|b) Board using external power supply for Vin and GND for the perimetersignal. Three terminal blocks installed on the motor driver because Vin and GND of the motordiver are not connected to the sender board|800px]] |
Aktuelle Version vom 10. Juni 2018, 17:30 Uhr
The soldering of the sender will be described.
There are two options soldering the sender:
a) Use the DC/DC Converter for Vin and GND of the MC33926 motor driver. Here you solder two pins to Vin and GND and connect the pins with the sender board. This is the default Ardumower configuration.
b) Use an external powersupply for Vin and GND of the MC33926 motor driver. Then you solder three terminal connectors on the motordriver. Vin and GND of the motor driver are not connected with the sender board. With this configuration you can adapt the voltage for the perimeter signal in a wider range. 5V to 24V for example and increase the current for a stronger perimeter signal.
In the last pictures a) and b) will be referenced.
The potentiometers will not be soldered because they have no function. If you want to install them you can do this.