Soldering The Sender: Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
Roland (Diskussion | Beiträge) K |
Roland (Diskussion | Beiträge) |
||
Zeile 2: | Zeile 2: | ||
There are two options soldering the sender | There are two options soldering the sender | ||
+ | |||
a) Use the DC/DC Converter for Vin and GND of the MC33926 motor driver. This is the default Ardumoer configuration. | a) Use the DC/DC Converter for Vin and GND of the MC33926 motor driver. This is the default Ardumoer configuration. | ||
+ | |||
b) Use an external powersupply for Vin and GND of the MC33926 motor driver. Then you solder three terminal connectors on the motordriver. With this configuration you can adapt the voltage for the perimeter siganl in a wider range. 5V to 24V for example. | b) Use an external powersupply for Vin and GND of the MC33926 motor driver. Then you solder three terminal connectors on the motordriver. With this configuration you can adapt the voltage for the perimeter siganl in a wider range. 5V to 24V for example. | ||
Version vom 10. Juni 2018, 14:52 Uhr
The soldering of the sender will be described.
There are two options soldering the sender
a) Use the DC/DC Converter for Vin and GND of the MC33926 motor driver. This is the default Ardumoer configuration.
b) Use an external powersupply for Vin and GND of the MC33926 motor driver. Then you solder three terminal connectors on the motordriver. With this configuration you can adapt the voltage for the perimeter siganl in a wider range. 5V to 24V for example.
The potentiometers will not be soldered because they have no function. If you want to install them you can do this.