WIFI Perimeter Sender(English): Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Hardware connecting) |
|||
| Zeile 7: | Zeile 7: | ||
[[Datei:esp32-1.png|200px]] [[Datei:esp32-2.png|200px]] [[Datei:esp32 layout.png|200px]] | [[Datei:esp32-1.png|200px]] [[Datei:esp32-2.png|200px]] [[Datei:esp32 layout.png|200px]] | ||
| + | |||
| + | INA3221 | ||
| + | |||
| + | |||
| + | Small OLED Display | ||
| + | |||
| + | |||
| + | DC/DC Converter | ||
| + | |||
| + | L298N motor Driver. | ||
| + | |||
---- | ---- | ||
ESP32 DEV KIT replace the bluetooth module HC05 to communicate with PCB1.3, so you can build a small PCB to connect all wire, or order some of them from JLCPCB for example (The same board is also use to build the WIFI sender.) | ESP32 DEV KIT replace the bluetooth module HC05 to communicate with PCB1.3, so you can build a small PCB to connect all wire, or order some of them from JLCPCB for example (The same board is also use to build the WIFI sender.) | ||
Version vom 14. März 2021, 09:30 Uhr
WIFI Perimeter sender.
Hardware connecting
You need :
ESP32 DEV KIT V1 (or later but with same pin diagram).
INA3221
Small OLED Display
DC/DC Converter
L298N motor Driver.
ESP32 DEV KIT replace the bluetooth module HC05 to communicate with PCB1.3, so you can build a small PCB to connect all wire, or order some of them from JLCPCB for example (The same board is also use to build the WIFI sender.)
