Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→New rubber tires) |
(→New rubber tires) |
||
Zeile 38: | Zeile 38: | ||
https://forum.ardumower.de/threads/traktion.22179 | https://forum.ardumower.de/threads/traktion.22179 | ||
+ | |||
+ | https://forum.ardumower.de/threads/3d-teile-und-zubeh%C3%B6r-f%C3%BCr-den-ardumower.22588/ | ||
=Pictures= | =Pictures= |
Version vom 28. April 2020, 01:54 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to run up higher slopes with it (tested up to 30 percent). This works by
- turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front)
- modifying the tire profile (give it more grip)
- Modify tire profile OR
- Off-road version (sand etc.): A bicycle tube is added around the tire
Needed parts
- cup
- acrylic glas sheet (1mm)
- rubber band
Turning front drive into rear drive
- swap motor cables (right and left)
- swap odometry cables (right and left)
- swap battery charging pin cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side
New rubber tires
https://forum.ardumower.de/threads/traktion.22179
https://forum.ardumower.de/threads/3d-teile-und-zubeh%C3%B6r-f%C3%BCr-den-ardumower.22588/
Pictures
Videos
- Demo
- Optimized tires
- Bicycle tube tires for 'off-road'
- Ardumower rear/front driven climbing difference