Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Abstract) |
(→Pictures) |
||
Zeile 22: | Zeile 22: | ||
File: Ardumower_mountains3.jpg| Step 2: Add acrylic glass sheet | File: Ardumower_mountains3.jpg| Step 2: Add acrylic glass sheet | ||
File: Ardumower_mountains5.jpg| Step 3: Add rubber band | File: Ardumower_mountains5.jpg| Step 3: Add rubber band | ||
− | File: | + | File: Ardumower_mountains2.jpg| Step 4: Modify charging station |
+ | File: Ardumower_mountain_tires.jpg| Step 5: Modify tire profile | ||
File: Ardumower_mountain_tires_profile.jpg | File: Ardumower_mountain_tires_profile.jpg | ||
− | |||
</gallery> | </gallery> | ||
Version vom 18. September 2014, 10:31 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to run up higher slopes with it (up to 45 degree). This works by
- turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front)
- modifying the tire profile
Turning front drive into rear drive
- swap motor cables (right and left)
- swap odometry cables (right and left)
- swap battery charging pin cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side
Needed parts
- cup
- acrylic glas sheet
- rubber band