Ardumower Chassis 'mountain mod': Unterschied zwischen den Versionen
Aus www.wiki.ardumower.de
(→Turning front drive into rear drive) |
(→Pictures) |
||
Zeile 20: | Zeile 20: | ||
<gallery> | <gallery> | ||
File: Ardumower_reverse.jpg | Step 1: reverse the direction (front and back), add cup | File: Ardumower_reverse.jpg | Step 1: reverse the direction (front and back), add cup | ||
+ | File: Ardumower_mountains_top.jpg| Coil at back position | ||
+ | File: Ardumower_mountains_side.jpg| | ||
File: Ardumower_mountains3.jpg| Step 2: Add acrylic glass sheet | File: Ardumower_mountains3.jpg| Step 2: Add acrylic glass sheet | ||
File: Ardumower_mountains5.jpg| Step 3: Add rubber band | File: Ardumower_mountains5.jpg| Step 3: Add rubber band |
Version vom 12. November 2014, 15:09 Uhr
Inhaltsverzeichnis
Abstract
This page describes how to modify the Ardumower Chassis to run up higher slopes with it (up to 45 degree). This works by
- turning the front drive into a rear drive and so requires to reverse the drive direction (so front is back and back is front)
- modifying the tire profile (give it more grip)
Needed parts
- cup
- acrylic glas sheet
- rubber band
Turning front drive into rear drive
- swap motor cables (right and left)
- swap odometry cables (right and left)
- swap battery charging pin cables (right and left)
- disable ultrasonic sensor
- move perimeter coil from old front to old back side