Bumper-Sensor
Aus www.wiki.ardumower.de
Version vom 15. Januar 2016, 00:38 Uhr von Alexanderg (Diskussion | Beiträge)
Inhaltsverzeichnis
Einführung
Ardumower's bumper sensor (called 'BumperDuino') is based on a pressure sensor and helps us to detect obstacles.
The PCB module and sensor can be purchased as complete kit via the shop .
Bauanleitung
Building instructions can be found in the BumperDuino manual.
Schaltbilder
Code
You can download the Arduino Code here. Important: Choose 'Arduino Uno' as bootloader.
To upload the code, set jumper to 'VUSB' and connect an USB-TTL adapter to J4 (USB-LIGHT) as follows:
J4 (USB-LIGHT) 1 -- USB-TTL GND 2 -- not used 3 -- USB-TTL +5V 4 -- USB-TTL TX 5 -- USB-TTL RX 6 -- USB-TTL DTR (reset)